Skip to content
AtomicHobbies

Small hobbies for the gaps in your day.

All hobbies
Craftsbeginner5 minutes

Lucky Paper Stars

A is a puffy little five-pointed star folded from one long strip of paper: tie a knot, wrap the strip around it, tuck the end and press the sides in. Each one fits on a fingertip, and people fold them by the dozen to fill a jar or give as a small good-luck gift. A sheet of printer paper holds enough strips for 16 stars.

What you'll do

Fold a sheet of printer paper into 16 long strips, cut one off, tie it into a flat pentagon knot, wrap the strip around the pentagon to the end, tuck it in and press each side with a fingernail so it puffs into a star.

A puffy five-pointed paper lucky star next to a long paper strip with a flat pentagon knot tied in it

At a glance

Time
5 minutes for your first session
Cost
Nothing to buy. It uses things you already have at home.
You need
One sheet of printer paper, Scissors

What you need

Required

  • One sheet of printer paper × 1 sheet, US letter (8.5 x 11 inches) or A4, which makes 16 strips · $0 · household

    Plain copy paper works well. Colored paper, wrapping paper or a magazine page make brighter stars. Any paper thin enough to fold easily will do; thick card cracks when you puff it.

    Alternatives: Colored paper, Wrapping paper, A magazine page

  • Scissors × 1 pair · $0 · household

    For cutting the strip off the sheet. You can also tear carefully along a sharp crease.

Nice to have

  • A small jar or bowl × 1 · $0 · household

    Somewhere to keep finished stars. A clean jam jar is the classic home for them.

How to do it

  1. Lay the sheet with a long edge toward you. Fold it in half so the two long edges meet, and . Keep it folded and fold it in half the same way again, then again, then a fourth time, creasing each fold hard. Unfold the sheet: the creases split it into 16 long strips, each about 1.3 cm (1/2 inch) wide and 28 to 30 cm (11 to 12 inches) long. Cut along the crease nearest one long edge, which gives you one strip. It worked if the strip is the same width from end to end, about 20 times longer than it is wide. Common mistake: a strip that narrows at one end, which makes a lopsided . Line up the edges carefully on each fold.

    Show help

    crease: A sharp fold line made by pressing the fold flat with a fingernail.

    Tip: Common mistake: creasing the wraps too sharply. Soft folds along the edges leave the star room to puff; hard creases make the sides stiff and they crack instead of denting.

  2. Hold the strip with about 3 cm (1 1/4 inches) of short end on your left. Bend the strip into a loop and pass the short end through it, as if starting a knot in a shoelace. Pull both ends very gently until the loop shrinks into a small, flat knot, then press it flat on the table. Ease the paper until the knot lies as a flat five-sided shape, a , with every edge crisp, no gaps at the corners and the strip lying flat, not twisted. Fold the short end over onto the pentagon and tuck it under the layer beside it; if it sticks out past the pentagon's edge, trim it to fit first. It worked if you have a neat flat pentagon with one long tail coming out of it. Common mistake: pulling hard, which crumples or tears the strip. Tighten slowly and stop as soon as the shape is flat.

    Show help

    pentagon: A flat shape with five straight sides. The knot in the strip flattens into one, and it becomes the body of the star.

    Tip: Common mistake: creasing the wraps too sharply. Soft folds along the edges leave the star room to puff; hard creases make the sides stiff and they crack instead of denting.

  3. Hold the by its flat faces between thumb and finger. Fold the long strip back over the nearest edge of the pentagon so it lies flat across the other face. The strip naturally lines up with the next edge; fold it over that edge too, turning the pentagon over as you go. Keep wrapping, one edge at a time, always following the pentagon's sides so each wrap lies exactly on top of the last edge, with no paper peeking over. Stop when about 3 cm (1 1/4 inches) of strip is left. It worked if the pentagon grows thicker but keeps its five neat sides. Common mistake: folding the strip at a slight angle, so it slides off the edge and the shape grows lumpy. If that happens, unwrap one turn and refold along the edge.

    Show help

    Tip: Common mistake: creasing the wraps too sharply. Soft folds along the edges leave the star room to puff; hard creases make the sides stiff and they crack instead of denting.

  4. Fold the last bit of strip over the next edge as before, then slide its end under the top layer of the previous wrap, like tucking in a shirt. If it is too long to hide, trim it so it reaches just under that layer. It worked if no loose end sticks out and the holds together when you let go.

    Show help

    Tip: Common mistake: creasing the wraps too sharply. Soft folds along the edges leave the star room to puff; hard creases make the sides stiff and they crack instead of denting.

  5. Hold the by two of its thin edges, the way you would hold a coin by its rim. Press your fingernail into the middle of one of the five edges, pushing it inward so the edge dents in and the corners on either side pop out. Turn the pentagon and do the same on all 5 edges, then go round once more, pressing a little deeper each time, until each edge caves in and the star stands puffy. You did it: a small, five-pointed puffy star from one strip of paper. If an edge won't dent, the strip was wrapped too tightly or creased too hard; press gently and keep going round. Next time, fold 5 in different colors from one sheet, or start a jar and add a star each day.

    Show help

    puff: The last step, pressing the middle of each of the pentagon's five edges inward so it swells into a three-dimensional star.

    Tip: Common mistake: creasing the wraps too sharply. Soft folds along the edges leave the star room to puff; hard creases make the sides stiff and they crack instead of denting.

Lucky Paper Stars · Step 1 of 5

Tips

  • Common mistake: creasing the wraps too sharply. Soft folds along the edges leave the star room to ; hard creases make the sides stiff and they crack instead of denting.

  • Keep the strip long and thin: guides use anything from about 13 to 30 times longer than it is wide, and the strips here are about 21. A strip too short leaves a flat, floppy star; one far too long leaves more paper than the star can hide.

  • Press the sides in with the side of a fingernail, not the tip. The tip can poke through thin paper.

  • Fold all 16 strips from a sheet at once and keep them in an envelope, so you can fold a star whenever you have a minute.

  • Wider strips make bigger stars. A strip 2.5 cm (1 inch) wide and 50 cm (20 inches) long, taped together from two pieces, makes a star big enough to hang.

Glossary

pentagon
A flat shape with five straight sides. The knot in the strip flattens into one, and it becomes the body of the star.
lucky star
A small puffy star folded from a paper strip, often made in large numbers and kept in a jar or given as a good-luck gift.
crease
A sharp fold line made by pressing the fold flat with a fingernail.
puff
The last step, pressing the middle of each of the pentagon's five edges inward so it swells into a three-dimensional star.

Communities

Resources

Frequently asked questions

How long does a lucky star take?

About 5 minutes for the first one, including cutting the strip. After a few, a star takes under a minute.

What size strip do I need?

About 1.3 cm (1/2 inch) wide and 28 to 30 cm (11 to 12 inches) long, which is what you get by folding a sheet of letter or A4 paper lengthwise in half four times. Other sizes work too, from about 1 cm by 30 cm to 2.5 cm by 33 cm (1 by 13 inches); keep the strip at least 13 times as long as it is wide.

Do I need special origami paper?

No. Printer paper, magazine pages and wrapping paper all work. Packs of pre-cut star strips exist and are handy for folding hundreds, but they fold exactly the same way.

Why won't my star puff up?

The wraps were creased too hard or pulled too tight. Next time, fold gently along each edge, and when puffing, press the middle of each side slowly from the center outward.

Why is my pentagon lopsided?

The knot was pulled tighter on one side, or the strip twisted. Loosen the knot slightly and ease each edge straight before you start wrapping; an even strip from step 1 helps too.

What can I do with lucky stars?

Fill a jar, scatter them on a table for a party, glue one to a card, or thread a needle through the side of a few for a small garland.

Something off in this guide?

Tried it? Earn the badge

Rate it below and the Lucky Paper Stars badge goes in your account.

How was it?

How much of a challenge was it?

Pass it on

Did you enjoy lucky paper stars? Share it with your friends!

Someone you know has 5 spare minutes too.

Sign in

A free account: just your email, no password. We'll email you a link that brings you back here.

No password. We only use your email to sign you in. Privacy

pentagon

A flat shape with five straight sides. The knot in the strip flattens into one, and it becomes the body of the star.

lucky star

A small puffy star folded from a paper strip, often made in large numbers and kept in a jar or given as a good-luck gift.

It is also called a wishing star or a puffy star. Shops sell pre-cut strips in packs, but strips cut from any paper fold the same way.

crease

A sharp fold line made by pressing the fold flat with a fingernail.

Crease hard when marking strips in step 1, but only lightly when wrapping, so the star can puff.

puff

The last step, pressing the middle of each of the pentagon's five edges inward so it swells into a three-dimensional star.

Get new hobbies by email

A short email when new hobbies and new levels land. No spam, unsubscribe anytime.

We only use your email to send these. Privacy

Tell us what you think

We only use your email to reply. Privacy