Skip to content
AtomicHobbies

Small hobbies for the gaps in your day.

All hobbies
Craftsbeginner5 minutes

Paper Boats

Fold the classic paper boat from one rectangle of paper, then launch it in a sink or bowl. It takes 5 minutes, uses the same hat-to-boat trick people have folded for over 200 years, and really floats.

What you'll do

Fold a paper boat from one sheet of printer paper and float it in a sink or bowl with a coin as cargo.

A folded paper boat with a pointed center sail floating on small waves

At a glance

Time
5 minutes for your first session
Cost
Nothing to buy. It uses things you already have at home.
You need
One sheet of printer paper, A sink, bowl or bathtub with 2 inches of water

What you need

Required

  • One sheet of printer paper · $0 · household

    Letter or A4. Any rectangle works; the boat is about 6 inches long from a letter sheet.

    Alternatives: A sheet of newspaper for a big boat, A magazine page, whose glossy coating floats longer

  • A sink, bowl or bathtub with 2 inches of water · $0 · household

    Any container big enough for a 5-inch boat. A baking dish works too.

    Alternatives: A puddle outside

Nice to have

  • A few coins · $0 · household

    Cargo to test how much your boat can carry.

    Alternatives: Paper clips, Dried beans

How to do it

  1. Lay the sheet in portrait, the short edges at top and bottom. Fold the top edge down to the bottom edge and hard with your thumbnail, so the fold is now at the top. You hold a rectangle about 8.5 inches wide and 5.5 inches tall on letter paper. Now fold it in half the other way, left edge to right edge, a crease only at the folded top, and unfold that second fold. The small pinch marks the center. Line the edges up exactly before creasing; if they are off by more than an eighth of an inch the boat will lean and take on water.

    Show help

    crease: A sharp folded line, pressed flat with a thumbnail so later folds land in the right place.

    pinch: A short crease made only at an edge, used to mark a spot without creasing the whole sheet.

    Tip: Common mistake: pulling the final boat open too fast. Ease the two points apart slowly and it opens without tearing the center.

  2. With the folded edge still at the top, fold the top-left corner down and in so the left half of the top fold lies exactly along an imaginary line running straight down from the center , making a triangle. Do the same with the top-right corner. The two triangles meet at the center line and look like a house roof, with a strip of about 1.25 inches left below them. Fold the front layer of that strip up over the triangles and . Turn it over and fold the back strip up the same way. You now have a paper hat. If the roof triangles overlap, unfold and line their edges up on the pinch.

    Show help

    Tip: Common mistake: pulling the final boat open too fast. Ease the two points apart slowly and it opens without tearing the center.

  3. Pick up the hat and put your thumbs inside its open bottom edge. Pull the middle of the front and back apart while pushing the two bottom corners toward each other until they meet. Flatten it on the table: it is now a diamond shape with the open edge down the middle. The ends of the brims overlap at the bottom corner; tuck one under the other so it lies flat. The common mistake is flattening it lopsided; check that the center seams on front and back line up exactly, one on top of the other.

    Show help

    Tip: Common mistake: pulling the final boat open too fast. Ease the two points apart slowly and it opens without tearing the center.

  4. Hold the diamond with the open side at the bottom. Fold the front bottom corner up to the top point and . Turn it over and fold the back bottom corner up to the top point too. It is a small triangle again. Now repeat step 3: thumbs into the open bottom, push the two bottom corners together, and flatten it into a smaller diamond, about half the size of the first one. Crease every edge firmly. If the paper bunches at the bottom point, open it slightly and let the inside layers slide into place before flattening.

    Show help

    Tip: Common mistake: pulling the final boat open too fast. Ease the two points apart slowly and it opens without tearing the center.

  5. Hold the small diamond with the open side at the top. the two top points, one in each hand, and pull them gently apart and outward. The middle rises into a sail, the bottom opens into a , and you have a boat. Pinch along the bottom to flatten it so it sits level, and open the hull a little with a finger. Set it on 2 inches of water in a sink or bowl. Pull too hard and it tears at the center, so go slowly. Add coins one at a time and count how many it carries before it sinks. You did it: a boat that floats from one sheet. Next time, rub crayon all over the outside first so it stays afloat for much longer.

    Show help

    hull: The bottom of a boat, the part that sits in the water.

    cargo: Whatever a boat carries. Here, coins used to test how strong your boat is.

    Tip: Common mistake: pulling the final boat open too fast. Ease the two points apart slowly and it opens without tearing the center.

Paper Boats · Step 1 of 5

Tips

  • Common mistake: pulling the final boat open too fast. Ease the two points apart slowly and it opens without tearing the center.

  • Printer paper soaks through in 5 to 10 minutes. A glossy magazine page, or a crayon rubbed over the outside, keeps it floating much longer.

  • Put coins in the middle of the , not at one end, or the boat tips and fills with water.

  • Make it from newspaper and stop after step 2 to get a hat big enough to wear.

Glossary

crease
A sharp folded line, pressed flat with a thumbnail so later folds land in the right place.
pinch
A short crease made only at an edge, used to mark a spot without creasing the whole sheet.
hull
The bottom of a boat, the part that sits in the water.
cargo
Whatever a boat carries. Here, coins used to test how strong your boat is.

Communities

Resources

Frequently asked questions

How long will my paper boat float?

Printer paper usually floats 5 to 10 minutes before it gets soggy. Glossy paper or crayon-coated paper can last much longer.

Can I use square paper?

This boat needs a rectangle. A square gives a stubby shape that is hard to open. If you only have squares, fold the square in half first and use that rectangle.

My boat tips over. Why?

Usually the bottom is not flattened or the folds were lopsided. Pinch the bottom of the hull flat so it sits level, and keep the cargo in the middle.

Is this the same as origami?

Yes. It is a traditional fold from one sheet with no cuts or glue, known in both Europe and Japan for centuries.

What should I try next?

Try a boat from a full sheet of newspaper, race two boats by blowing on them, or learn a flat-bottomed boat that carries more cargo.

Something off in this guide?

Tried it? Earn the badge

Rate it below and the Paper Boats badge goes in your account.

How was it?

How much of a challenge was it?

Pass it on

Did you enjoy paper boats? Share it with your friends!

Someone you know has 5 spare minutes too.

Sign in

A free account: just your email, no password. We'll email you a link that brings you back here.

No password. We only use your email to sign you in. Privacy

crease

A sharp folded line, pressed flat with a thumbnail so later folds land in the right place.

pinch

A short crease made only at an edge, used to mark a spot without creasing the whole sheet.

hull

The bottom of a boat, the part that sits in the water.

cargo

Whatever a boat carries. Here, coins used to test how strong your boat is.

Get new hobbies by email

A short email when new hobbies and new levels land. No spam, unsubscribe anytime.

We only use your email to send these. Privacy

Tell us what you think

We only use your email to reply. Privacy