Ribbon Rosettes
A is the pleated, round prize ribbon pinned on the winner at a horse show or county fair. You can fold a convincing one from a single sheet of printer paper and a scrap of cereal box, write your own title in the middle, and pin it on someone who deserves it. It takes about 15 minutes, with things you already have at home.
What you'll do
Fold two paper strips into an accordion, fan them into a flat pleated rosette, lock it with a cardboard circle, add notched tails and a hand-lettered center label, then award it to someone.
At a glance
- Time
- 15 minutes for your first session
- Cost
- Nothing to buy. It uses things you already have at home.
- You need
- A sheet of printer paper, Thin cardboard, Scissors, Glue stick or clear tape, A pencil and a dark marker
- Members
What you need
Required
- A sheet of printer paper × 1 sheet (8.5 x 11 inches or A4) · $0 · household
One sheet gives four 2-inch strips: two for the rosette, one for the tails and one for the center label. Colored paper, wrapping paper or a magazine page looks more like a real prize ribbon, but plain white works and takes marker well.
Alternatives: Wrapping paper, A magazine or catalog page, Colored construction paper
- Thin cardboard × One piece about 3 x 3 inches · $0 · household
From a cereal, cracker or tissue box. It becomes the stiff backing circle that holds the pleats flat. You also need something round about 2 inches across to trace, such as the ring on the bottom of a soda can or a small jar lid.
Alternatives: A cardboard coaster, An old greeting card
- Scissors × 1 pair · $0 · household
Any pair that cuts cardboard. Kitchen scissors are fine.
- Glue stick or clear tape × 1 glue stick, or about 12 inches of tape · $0 · household
Either holds this size of rosette, and tape grips the springy pleats best on a first try. White school glue also works but needs a few minutes under a book to set. A hot glue gun is quickest if you already own one; watch your fingertips.
Alternatives: White school glue, A hot glue gun, Double-sided tape
- A pencil and a dark marker × 1 of each · $0 · household
Pencil to plan the lettering, marker to ink it. A ballpoint pen works if it is all you have; go over each letter twice.
Alternatives: A ballpoint or felt-tip pen
Nice to have
- Leftover ribbon × About 30 inches, 1 to 1.5 inches wide, plus 10 inches for tails · $0 · household
Gift-wrap ribbon left from a present makes a fabric-look rosette. It is pleated straight onto the cardboard circle instead of folded first; see the FAQ. Paper is easier for a first one.
Alternatives: Crepe paper streamer
How to do it
Pick up where you left off
Step ·
Lay the paper with a long edge toward you. You need strips about 2 inches wide that run the full 11-inch length. To measure without a ruler, fold the sheet in half so the two long edges meet, then in half the same way again, unfold, and cut along the 3 creases: that gives four strips just over 2 inches wide. Two become the , one the tails, and one the center label. Next, find something round about 2 inches across, such as the ring on the bottom of a soda can or a small jar lid. Trace it once on the cardboard and once on the fourth strip, and cut out both circles. The cardboard circle is the backing; the paper circle is the center label. It worked if you have 3 strips that match in width and 2 circles the same size. Common mistake: wavy strips. A strip that is wider at one end makes a lopsided rosette, so cut slowly along the crease.
Show helpHide help
Tip: Common mistake: crooked pleats. Halving the strip four times before you accordion-fold gives perfectly even sections without a ruler, and even sections are what make the rosette look store-bought.
Set one strip aside for the tails. Take another, fold it in half end to end and crease hard with your thumbnail, then fold it in half again, and again, and once more: four folds in total. Unfold it. You now have 16 even sections, each about 11/16 of an inch wide. Now refold it as an : fold the first section up, the next one down, the next up, and so on, so every crease alternates and the strip squashes into a neat stack. Repeat with the second strip. It worked if each strip collapses into a tidy zigzag about 3/4 inch long and springs open like a fan. Common mistake: two creases folding the same way in a row, which makes a flat spot. If a crease points the wrong way, just pinch it the other way.
Show helpHide help
accordion: Folding a strip back and forth, up then down, so it collapses into a zigzag like the bellows of an accordion.
Tip: Common mistake: crooked pleats. Halving the strip four times before you accordion-fold gives perfectly even sections without a ruler, and even sections are what make the rosette look store-bought.
Lay the two folded strips end to end so the zigzag carries on from one to the other; flip the second strip over if its first fold points the wrong way. Overlap the last section of the first strip onto the first section of the second, and glue or tape them flat so they act as one long strip of about 30 . Bring the two loose ends together the same way to make a ring, like a short, ridged tube 2 inches tall. Stand the ring on the table. With your fingertips, push the top edge down and in toward the center, working around the ring, so the top edges of the pleats gather into a small hole in the middle while the bottom edges fan out on the table. You end up with a flat, round fan about 4.5 inches across. Keep one hand pressed on it. It worked if the pleats radiate evenly like the spokes of a wheel. Common mistake: a bunched side. Before you go on, nudge the pleats with a fingertip so the gaps look the same all the way round.
Show helpHide help
pleats: The folded sections of the strip. In a rosette they fan out from the center like spokes.
Tip: Common mistake: crooked pleats. Halving the strip four times before you accordion-fold gives perfectly even sections without a ruler, and even sections are what make the rosette look store-bought.
Still holding the fan flat, carefully flip it face down. If you have tape, lay two strips across the back in an X first, whichever adhesive you use for the circle; it stops the springing open. Then cover one side of the cardboard circle with glue stick, right to the edge, and press it onto the center of the back so it covers the hole and grips the inner ends of every pleat. Press hard for a slow count of 30. Using only tape, fix the circle on with 4 small loops of tape over the X instead. Let go and turn it over. It worked if the stays flat and round on its own. Common mistake: letting go too soon. If the pleats spring up, press again for another 30 seconds, or add more tape across the back.
Show helpHide help
backing circle: The stiff cardboard disc glued to the back that holds every pleat flat and gives you something to pin through.
Tip: Common mistake: crooked pleats. Halving the strip four times before you accordion-fold gives perfectly even sections without a ruler, and even sections are what make the rosette look store-bought.
Cut the third strip into two 5-inch pieces for tails. On each one, fold the bottom end in half the long way, so the long edges meet. Starting on the fold about 3/4 inch up from the end, snip at a slant down to the bottom corner where the open edges meet; unfold it and you have a V-shaped cut into the end. Glue or tape the top inch of each tail to the back circle so they hang below the and spread apart like an upside-down V. Now letter the paper circle while it is flat on the table: lightly pencil one big word or number in the middle, such as 1st, CHAMPION or BEST, plus an optional small line above or below, such as Best Pancakes or Top Dog. Go over it in marker and glue the label onto the front center. It worked if the label covers the center hole and the tails show from the front. Common mistake: lettering that starts at the left and runs off the edge. Write the middle letter first, then work outward on each side.
Show helpHide help
dovetail notch: A V-shaped cut in the end of a ribbon tail, so it ends in two points like a swallow's tail.
Tip: Common mistake: crooked pleats. Halving the strip four times before you accordion-fold gives perfectly even sections without a ruler, and even sections are what make the rosette look store-bought.
Pick the winner: the person who cooked dinner, a child who finished their homework, a dog who sat nicely, or a coworker who fixed the printer. Hand it over with a short ceremony, a drumroll on the table counts, and say what the prize is for. Pin it on with a safety pin through the cardboard, tape it to their door, or prop it on their desk. You did it: you made a real prize-style and gave it away. Next session, make a giant one from a 6-inch-wide strip of wrapping paper for a birthday, or a set of three, first, second and third, for a family game night.
Show helpHide help
Tip: Common mistake: crooked pleats. Halving the strip four times before you accordion-fold gives perfectly even sections without a ruler, and even sections are what make the rosette look store-bought.
Tips
Common mistake: crooked . Halving the strip four times before you accordion-fold gives perfectly even sections without a ruler, and even sections are what make the look store-bought.
For a colored rim on plain printer paper, run a marker along one long edge of each strip before you fold. Keep that edge at the bottom when you flatten the ring in step 3 and it becomes the outer ring of the .
A fuller needs more , not a wider strip. Fold a third strip from a second sheet, snip off one end section so the zigzag still alternates all the way round, and add it to the ring in step 3.
Make the label specific. 'Best Parallel Parking, Tuesday' gets a bigger laugh, and a longer life on the fridge, than a plain '1st'.
Using ribbon, work on top of the cardboard circle and glue every third pleat as you go. Fabric springs back far more than paper does.
Glossary
- rosette
- A round, pleated award ribbon with a center disc and hanging tails, given for placings at horse shows, fairs and dog shows.
- accordion
- Folding a strip back and forth, up then down, so it collapses into a zigzag like the bellows of an accordion.
- pleats
- The folded sections of the strip. In a rosette they fan out from the center like spokes.
- backing circle
- The stiff cardboard disc glued to the back that holds every pleat flat and gives you something to pin through.
- dovetail notch
- A V-shaped cut in the end of a ribbon tail, so it ends in two points like a swallow's tail.
Communities
Resources
- How to Make a Paper Award Ribbon (Polka Dot Chair)The same strip-and-pleat method with patterned cardstock, scored every half inch, for a crisper rosette.
- DIY Paper Award Ribbons (GeekMom)Pleats a party streamer straight onto a cardstock circle, the method that also suits leftover ribbon.
- Giant Prize Ribbons (Oh Happy Day)An oversized version accordion-folded from wrapping paper, a good next project for a party.
Frequently asked questions
How long does it take to make a ribbon rosette?
About 15 minutes for your first paper one, including cutting. Once you know the folds, a second one takes under 10 minutes, and a batch of three for first, second and third goes faster still because you cut all the strips at once.
Do I need to buy ribbon?
No. The starter rosette uses one sheet of printer paper, a scrap of cereal box, scissors and a glue stick or tape, so there is nothing to buy. Leftover gift ribbon or wrapping paper makes it look fancier if you have some.
How do I make one from real ribbon instead of paper?
Use about 30 inches of ribbon 1 to 1.5 inches wide. Glue the end to the back edge of the cardboard circle, then pinch a pleat about half an inch deep, lay it down slightly overlapping the last, and glue every third pleat as you work around the circle. When you get back to the start, glue the end down, trim the extra, and add tails and a label the same way as the paper version.
Why won't my rosette stay flat?
The backing circle is not gripping the inner ends of the pleats. Press it down again for 30 seconds, make sure the glue reaches the edge of the cardboard, or tape an X across the back first. Uneven pleats also push the fan up on one side, so spread them evenly before gluing.
What do the rosette colors mean?
At most US horse shows blue is first and red is second, with yellow and white for the places after. In the UK the top two are usually swapped, red for first and blue for second. For your own awards, any color goes.
Can kids make these?
Yes. Children around 6 and up can fold and glue a paper rosette with a little help cutting the cardboard. Skip the hot glue gun with young kids; a glue stick holds the paper version fine.
Something off in this guide?