Skip to content
AtomicHobbies

Small hobbies for the gaps in your day.

All hobbies
Craftsbeginner5 minutes

Knot Tying

Learn three knots that solve real problems: a that keeps a cord from slipping out, a square knot that joins two ends, and the bowline, a loop that will not tighten or slip. All you need is a shoelace, and in 5 minutes you can tie and test each one.

What you'll do

Tie and test a figure-eight stopper, a square knot and a bowline using one shoelace.

Two cords joined in a square knot, pulled tight from both ends

At a glance

Time
5 minutes for your first session
Cost
Nothing to buy. It uses things you already have at home.
You need
A shoelace or piece of string about 2-3 feet long, Something to tie around

What you need

Required

  • A shoelace or piece of string about 2-3 feet long · $0 · household

    A thicker lace is easier to see and untie than thin thread. Pull one out of a spare shoe.

    Alternatives: A phone charging cable, A drawstring from a hoodie, A length of yarn or kitchen twine

  • Something to tie around · $0 · household

    A chair leg, a table leg, a water bottle or your own wrist, used to test the knots under a pull.

    Alternatives: Your knee

How to do it

  1. Hold the lace with one end hanging from your right hand. The end you move is the ; the long rest of the lace is the . Tie a figure-eight: make a loop by crossing the working end over the standing part, take it around behind the standing part, then push it down through the loop from the front. Pull both sides. It should look like a flat number 8, fatter than a plain overhand knot. That is a , used at the end of a cord so it cannot slip through a hole or buckle. If you see only one twist, you tucked through the wrong side; untie and go behind the standing part before tucking.

    Show help

    working end: The end of the cord you move to tie the knot.

    standing part: The long, inactive rest of the cord that the knot is tied around or that takes the load.

    stopper: A knot tied at the end of a cord to stop it slipping through a hole.

    Tip: Common mistake: tying a granny knot instead of a square knot. Say right over left, then left over right out loud every time until it is automatic.

  2. Wrap the lace once around a water bottle or your wrist so you hold one end in each hand. Say it out loud: right over left and under. Cross the right end over the left, tuck it under, and pull snug, like the first step of tying a shoe. Then left over right and under: cross the end now in your left hand over the one in your right, tuck it under and through, and pull both ends at once. Tighten it until the knot sits flat against the bottle. Leave at least 2 inches of tail on each end so it cannot work loose.

    Show help

    Tip: Common mistake: tying a granny knot instead of a square knot. Say right over left, then left over right out loud every time until it is automatic.

  3. Look at the finished knot. A real square knot looks like two interlocking loops lying flat, and both tails come out on the same side, both above or both below the wrap. If the knot sits twisted and the tails stick out on opposite sides at an angle, you tied a , the most common mistake, which slips under load. It happens when you go right over left twice. Untie it and redo the second half the opposite way. Then test: pull hard on both tails. A square knot holds; a granny turns and slides.

    Show help

    granny knot: A look-alike of the square knot made by crossing the same way twice. It slips and jams.

    Tip: Common mistake: tying a granny knot instead of a square knot. Say right over left, then left over right out loud every time until it is automatic.

  4. Hold the in your left hand and the in your right, with about 12 inches of working end. Make a small loop in the standing part, about 1 inch across, so the working-end side crosses on top. Think of it as a rabbit hole with the standing part as a tree. Push the working end up through the hole from underneath, take it around behind the tree, and send it back down the hole. Hold the tail and the side of the big loop together in your right hand and pull the standing part with your left. If the whole thing falls apart, your small loop crossed underneath; flip that loop and try again.

    Show help

    Tip: Common mistake: tying a granny knot instead of a square knot. Say right over left, then left over right out loud every time until it is automatic.

  5. Drop the bowline's big loop over a chair leg and pull the hard, as if hauling something. The loop should keep its size and not shrink around the leg; that is the bowline's whole job. Now push the , the bend of lace around the standing part, toward the loop: it breaks open and unties easily even after a hard pull, which a plain knot will not do. You did it: you can stop a cord, join two ends, and make a loop that will not slip. Next session, tie each knot 3 times with your eyes closed, then learn the clove hitch for tying a line to a post.

    Show help

    collar: The bend of the working end that wraps around the standing part in a bowline.

    Tip: Common mistake: tying a granny knot instead of a square knot. Say right over left, then left over right out loud every time until it is automatic.

Knot Tying · Step 1 of 5

Tips

  • Common mistake: tying a instead of a square knot. Say right over left, then left over right out loud every time until it is automatic.

  • A square knot is for bundling and tying things like bandages or bags. Never use it to join two ropes that will hold a person or a heavy load.

  • Use two different colored laces when you start. Seeing which end goes where makes every knot easier to learn.

  • Leave a tail at least 2 inches long on every knot. Short tails let knots shake loose.

Glossary

working end
The end of the cord you move to tie the knot.
standing part
The long, inactive rest of the cord that the knot is tied around or that takes the load.
stopper
A knot tied at the end of a cord to stop it slipping through a hole.
granny knot
A look-alike of the square knot made by crossing the same way twice. It slips and jams.
collar
The bend of the working end that wraps around the standing part in a bowline.

Communities

Resources

Frequently asked questions

Is a square knot the same as a reef knot?

Yes. Reef knot is the sailing name and square knot is the common American name. They are the same knot.

Why does my bowline fall apart when I pull it?

The small loop was made the wrong way. The side of the cord leading to the working end must cross on top of the standing part. Flip the small loop and tie it again.

Can I use these knots for climbing?

No. Climbing and rescue need training and specific knots, backed up and checked by someone qualified. These are everyday knots for bags, tarps, laces and gear.

What is the best knot to learn next?

The clove hitch, for tying a line to a post or rail, and the two half hitches, for tying off a tarp or a load. Both take about a minute each to learn.

Does the type of string matter?

For practice, use anything 2-3 feet long that is not slippery. Thin fishing line or silky ribbon makes knots hard to see and quick to slip.

Something off in this guide?

Tried it? Earn the badge

Rate it below and the Knot Tying badge goes in your account.

How was it?

How much of a challenge was it?

Pass it on

Did you enjoy knot tying? Share it with your friends!

Someone you know has 5 spare minutes too.

Sign in

A free account: just your email, no password. We'll email you a link that brings you back here.

No password. We only use your email to sign you in. Privacy

working end

The end of the cord you move to tie the knot.

standing part

The long, inactive rest of the cord that the knot is tied around or that takes the load.

stopper

A knot tied at the end of a cord to stop it slipping through a hole.

granny knot

A look-alike of the square knot made by crossing the same way twice. It slips and jams.

collar

The bend of the working end that wraps around the standing part in a bowline.

Get new hobbies by email

A short email when new hobbies and new levels land. No spam, unsubscribe anytime.

We only use your email to send these. Privacy

Tell us what you think

We only use your email to reply. Privacy