Napkin Folding
Napkin folding turns a plain square of cloth or paper into a small standing shape for the table, with nothing but a few careful creases. The standing fan is the classic first fold: a row of pleats that opens up like a peacock's tail and props itself up on its own little . One napkin and a flat table are all it takes, and the same handful of folds dresses up a weeknight dinner or a holiday table.
What you'll do
Fold one napkin in half, pleat two-thirds of it like an accordion, fold it in half again and fold the plain end into a triangle stand, so a fan stands up on its own on the table.
At a glance
- Time
- 5 minutes for your first session
- Cost
- Nothing to buy. It uses things you already have at home.
- You need
- One square napkin, cloth or paper, A flat, clean table or counter
- Members
What you need
Required
- One square napkin, cloth or paper × 1 napkin, about 40-50 cm (16-20 inches) square when opened out · $0 · household
A cotton or linen dinner napkin holds the shape best. A paper dinner napkin works: open it out to its full square first. Small cocktail napkins are too small to stand. No napkin? A thin square dish towel or a square cut from a sheet of newspaper lets you practice.
Alternatives: Paper dinner napkin, opened out to full size, Thin square dish towel, A square of newspaper or gift wrap for practice
- A flat, clean table or counter × 1 · $0 · household
You crease against the table, so a smooth surface makes sharper folds than your lap.
Nice to have
- A plate or drinking glass × 1 · $0 · household
To stand the finished fan on or beside, so you can see how it looks at a real place setting.
- Iron and a little spray starch × 1 · $0 · household
Optional. A cloth napkin ironed flat, with a light spray of starch, keeps sharp pleats and stands taller. Skip it for a first try.
How to do it
Pick up where you left off
Step ·
Open the napkin out flat on the table, with the side you want people to see facing down (it ends up on the outside). Smooth out wrinkles with your palms. Bring the bottom edge up to meet the top edge, line up the two top corners, and run your palm along the new fold at the bottom to it. It worked if you have a rectangle twice as wide as it is tall, with the folded edge nearest you and the open edges at the top. Turn it so the long sides run left to right. Common mistake: corners that do not quite meet. Line them up before you crease; a crooked first fold makes every pleat lean.
Show helpHide help
crease: The sharp line left where you fold and press the napkin flat.
Tip: Common mistake: uneven pleats. If the pleats are different widths, the fan opens lopsided. Make the first pleat carefully and use it as a guide for every one after.
Start at the left short end. Fold a strip about 2.5 cm (1 inch) wide over to the right, through both layers, and press the from top to bottom. Turn the napkin over, fold the same width back the other way, and press again. Keep going, back and forth like a paper fan, always the same width and always parallel to the short end, until you have pleated about two-thirds of the length. On a 45 cm (18 inch) napkin that is about 12 pleats, and about 15 cm (6 inches) on the right stays flat. Pinch the pleats together in your left hand so they stay closed. It worked if the pleats stack into a neat block with crisp edges and the plain part sticks out to the right. Common mistake: pleats that get wider as you go. Use the first one as your ruler and lay each new pleat on top to check it.
Show helpHide help
accordion pleat: A row of folds that go back and forth, one up and one down, so the material zigzags like the bellows of an accordion.
Tip: Common mistake: uneven pleats. If the pleats are different widths, the fan opens lopsided. Make the first pleat carefully and use it as a guide for every one after.
Still pinching the pleats, fold the whole napkin in half the long way: bring the bottom edge up to meet the top edge, so the pleats bend in half and the new fold is at the bottom. The strip is now half as tall as before, about 11 cm (4 inches). The pleated block stays on the left, bent over on itself, and the plain part on the right folds in half too. Press along the new bottom fold. It worked if the pleats are now short and doubled over, with the new fold along the bottom, and the plain part on the right is a double-layered rectangle about 15 by 11 cm (6 by 4 inches). Common mistake: letting go of the pleats; they spring open. Keep them pinched until the is tucked in.
Show helpHide help
Tip: Common mistake: uneven pleats. If the pleats are different widths, the fan opens lopsided. Make the first pleat carefully and use it as a guide for every one after.
Keep the new fold at the bottom and the pleats pinched on the left. Take the top right corner of the plain part and fold it down and to the left, so the runs at a slant from the top of the last pleat to the bottom right corner. The plain part is now a triangle, and the tip of the folded-down corner pokes out about 3 cm (1 inch) below the bottom edge: fold that tip up and tuck it under the bottom of the triangle so it holds. Now the napkin upright on its bottom fold and swing the triangle back so it sticks out behind the pleats at a right angle, like the kickstand of a bicycle. Let go of the pleats: they spread upward into a fan. Nudge each pleat open evenly with a fingertip. You did it if the fan stands up on its own on a plate or the table and the pleats spread in an even half-circle. If it tips over, swing the triangle further out so it braces the fan, and check the tucked tip still holds. Next time, fold a fan for every place at the table, or try the , a tall standing fold made of triangles.
Show helpHide help
stand: The triangle folded from the plain end of the napkin. It sits behind the pleats and props the fan up, like a picture frame's back leg.
bishop's hat: A classic standing napkin fold, also called the bishop's mitre, shaped like a tall pointed hat with two peaks.
Tip: Common mistake: uneven pleats. If the pleats are different widths, the fan opens lopsided. Make the first pleat carefully and use it as a guide for every one after.
Tips
Common mistake: uneven pleats. If the pleats are different widths, the fan opens lopsided. Make the first pleat carefully and use it as a guide for every one after.
Crisp creases are everything. Press each fold against the table with the side of your thumb or a fingernail. Soft creases make a droopy fan.
Paper napkins are easier for practice because they hold a . Cloth napkins look better on the table, and a quick iron makes them behave almost like paper.
Practice on one napkin until you can fold it without looking at the steps, then fold the rest. A matching row of fans looks far better than one perfect fan and five rushed ones.
Glossary
- accordion pleat
- A row of folds that go back and forth, one up and one down, so the material zigzags like the bellows of an accordion.
- crease
- The sharp line left where you fold and press the napkin flat.
- stand
- The triangle folded from the plain end of the napkin. It sits behind the pleats and props the fan up, like a picture frame's back leg.
- bishop's hat
- A classic standing napkin fold, also called the bishop's mitre, shaped like a tall pointed hat with two peaks.
- starch
- A spray used when ironing cloth that makes the fabric slightly stiff, so folds hold their shape.
Communities
Resources
Frequently asked questions
How long does it take to learn napkin folding?
Your first standing fan takes about 5 minutes. By the third napkin you can fold one in about a minute, and most simple table folds take a few tries each to learn by heart.
Do I need cloth napkins?
No. A paper dinner napkin opened out to its full square works for every step here and actually holds creases better. Cloth looks nicer on a table, and an ironed cotton or linen napkin stands tallest.
Why does my fan fall over?
The stand is not bracing it or the pleats are too loose. Swing the triangle out so it sits at a right angle behind the fan, and make sure its tip is tucked under so the stand cannot unfold. Crisper pleats and a starched cloth napkin also stand better.
My napkin is a rectangle. Will it work?
Yes, the fan forgives a rectangle. In step 1, bring the two long edges together so you get a long strip, then pleat from a short end as usual.
Where does the folded napkin go on the table?
A standing fan usually sits in the middle of the plate or just to its left, beside the fork. It can also stand in an empty wine glass: skip the stand and just drop the bottom of the pleats into the glass.
Something off in this guide?