Paper Snowflakes
A paper snowflake is a sheet of printer paper folded into a narrow , snipped along its edges and opened into a lacy six-pointed star. Every cut repeats twelve times, so a few rough notches turn into a pattern that looks planned. One sheet and a pair of scissors make one in about 5 minutes.
What you'll do
Cut a sheet of printer paper into a square, fold it into a triangle, a smaller triangle and then thirds, trim the top at a slant, snip 3 or 4 notches into the folded sides and unfold a six-pointed snowflake.
At a glance
- Time
- 5 minutes for your first session
- Cost
- Nothing to buy. It uses things you already have at home.
- You need
- One sheet of printer paper, Scissors
- Members
What you need
Required
- One sheet of printer paper × 1 sheet, US letter (8.5 x 11 inches) or A4 · $0 · household
Plain copy paper is ideal: thin enough to cut through 12 layers, firm enough to hold its shape. Lined notebook paper, wrapping paper or a page from a magazine work too. Avoid card stock, which is too thick once folded.
Alternatives: Lined notebook paper, Wrapping paper, A magazine page
- Scissors × 1 pair · $0 · household
Any sharp pair. Small scissors with pointed tips make small notches easier; kitchen scissors work for a first try.
Nice to have
- A heavy book × 1 · $0 · household
Pressing the open snowflake under a book for a minute flattens the creases.
How to do it
Pick up where you left off
Step ·
Lay the sheet flat in front of you, the short edge at the top. Fold the top left corner down and across until the top edge lies exactly along the right edge, making a triangle. A strip of single paper is left below the triangle: about 6 cm (2.5 inches) tall on letter paper, 9 cm (3.5 inches) on A4. Run a fingernail along the diagonal fold, then cut off that strip along the bottom edge of the triangle and throw it away. Keep the triangle folded. It worked if the two edges meet exactly at the right corner, with no paper sticking out on either side. Common mistake: letting the edges drift apart at the far corner, which gives a lopsided square and a lopsided snowflake.
Show helpHide help
crease: A sharp fold line. Run a fingernail along each fold so the layers lie flat and line up.
Tip: Common mistake: cutting too little. First snowflakes often come out as a plain hexagon with a few nicks. Cut away about half of the wedge's paper; it always looks more delicate once it opens.
Turn the triangle so its long folded edge is at the bottom and the point is at the top. Bring the bottom right corner over to the bottom left corner, line the two corners up exactly, and . You now have a smaller triangle, 4 layers thick. Turn it so the square corner, where both folds meet, points straight down at you. That corner is the center of your snowflake. It worked if the corner at the bottom is a clean right angle, like the corner of a book, and the outer edges line up.
Show helpHide help
Tip: Common mistake: cutting too little. First snowflakes often come out as a plain hexagon with a few nicks. Cut away about half of the wedge's paper; it always looks more delicate once it opens.
Keep the center corner pointing down. Picture the open angle above it split into 3 equal slices, like a fan. Fold the right slice over toward the left, with the new fold starting exactly at the bottom point, then fold the left slice over on top of it. Before you , wiggle both flaps until each flap's outer edge lies exactly along the fold on the far side of the and nothing sticks out at the point. The paper now looks like a narrow arrowhead pointing down, with two uneven tails sticking up at the top. Press it flat and crease firmly. It worked if both long sides of the wedge are clean, straight folds that line up. Common mistake: making one slice wider than the others, which leaves a gap or overhang along one side. Unfold the last flap and adjust; uneven give a snowflake with one fat point.
Show helpHide help
wedge: The narrow, many-layered slice of paper you end up with after the thirds fold. Its point is the center of the snowflake.
thirds: Folding the paper into 3 equal slices that stack on top of each other, which is what gives a snowflake six points instead of four or eight.
Tip: Common mistake: cutting too little. First snowflakes often come out as a plain hexagon with a few nicks. Cut away about half of the wedge's paper; it always looks more delicate once it opens.
Hold the point down. Cut off the uneven tails with one slanted cut: start on one side about 9 cm (3.5 inches) up from the point and cut across to the other side about 7 cm (2.75 inches) up. The slant is what makes the six points. Now make 3 or 4 small cuts into the two long folded sides: a small triangle about 1 cm (3/8 inch) deep, a half circle, a narrow slit. Keep cuts near the point tiny, about 5 mm (1/4 inch), because the wedge is narrow there. Optionally snip 5 mm off the very point to make a hole in the center. Common mistake: cutting from one side all the way through to the other, which cuts the snowflake into pieces. Every cut must leave a strip of paper joining the two sides.
Show helpHide help
notch: A small cut-out shape, such as a triangle or half circle, snipped into the folded side of the wedge.
Tip: Common mistake: cutting too little. First snowflakes often come out as a plain hexagon with a few nicks. Cut away about half of the wedge's paper; it always looks more delicate once it opens.
Open it slowly, one layer at a time, peeling the layers apart at the outer edge rather than pulling at the thin cut parts. Lay it flat and smooth it with your palm, or press it under a heavy book for a minute. You did it: a six-pointed snowflake with every repeated around it. If a point is missing, the slanted cut was too low on that side; if it came apart, one cut went too far across. Next time, cut bigger and deeper shapes along both sides, or tape a few to a window as a set.
Show helpHide help
Tip: Common mistake: cutting too little. First snowflakes often come out as a plain hexagon with a few nicks. Cut away about half of the wedge's paper; it always looks more delicate once it opens.
Tips
Common mistake: cutting too little. First snowflakes often come out as a plain hexagon with a few nicks. Cut away about half of the 's paper; it always looks more delicate once it opens.
Cut into both long sides of the , not just one. Cuts on the two sides land in different places, which is what makes a lacy pattern instead of a row of holes.
If 12 layers are hard to cut, squeeze the flat with one hand and cut with the part of the blades closest to the hinge, where scissors are strongest. Thinner paper helps too.
The slant of the top cut sets the shape of the points: a steep slant gives long, spiky points, and a straight cut across gives a round, flower-like edge.
To keep a favorite pattern, sketch your cuts on the folded in pencil first, and save one folded, uncut wedge as a template for the next one.
Glossary
- wedge
- The narrow, many-layered slice of paper you end up with after the thirds fold. Its point is the center of the snowflake.
- thirds
- Folding the paper into 3 equal slices that stack on top of each other, which is what gives a snowflake six points instead of four or eight.
- crease
- A sharp fold line. Run a fingernail along each fold so the layers lie flat and line up.
- notch
- A small cut-out shape, such as a triangle or half circle, snipped into the folded side of the wedge.
- kirigami
- The Japanese name for the craft of folding and cutting paper. Paper snowflakes are a simple form of it.
Communities
Resources
- Red Ted Art (YouTube)A family craft channel with short paper snowflake videos, including a coffee-filter version and 3D snowflakes for later.
- How to make a six pointed snowflake (Red Ted Art)The same square, triangle and thirds fold written step by step, with ideas for cuts that join the points or leave holes.
- How to Make a Paper Snowflake (KiwiCo)A photo walkthrough from one sheet of printer paper, with a pencil method for finding the thirds.
Frequently asked questions
How long does a paper snowflake take?
About 5 minutes for a first one with simple notches. A detailed design with many small cuts can take 15 to 20 minutes, and folding gets quick after two or three.
What paper works best?
Thin printer or copy paper. It cuts cleanly through 12 layers and stays flat. Coffee filters and tissue paper are even easier to cut but crumple more; card stock is too thick to fold this many times.
Why do real snowflakes have six points?
Ice crystals form in a six-sided pattern because of how water molecules bond as they freeze. Folding into thirds copies that, which is why this fold looks more like real snow than a fold in half and half again.
Why did my snowflake fall apart?
A cut ran from one folded side through to the other. Keep a strip of uncut paper at least 3 mm (1/8 inch) wide running down the wedge so the arms stay joined.
Why does my snowflake have uneven points?
The thirds were not equal, or the square was not quite square. Line up the folded edges in step 3 exactly before creasing; small errors grow when the paper is opened.
What can I do with paper snowflakes?
Tape them to a window, string them on thread as a garland, or tuck one into a card. A small one cut from a sticky note makes a quick gift tag.
Something off in this guide?